PDA

View Full Version : FS: Billet Aluminum Grille for 88-89 Coupe/Sedan



markmdz89hatch
02-27-2009, 07:29 AM
Alright guys, I'm clearing out some of my goodies so I can fund getting this damn thing on the road this summer.

This is a billet grille that installs in the lower section of the bumper. Honestly, I'm not sure if you need to remove the horizontal plastics in the stock one, but I don't think you do.

This is used, but looks very nice, and should look pretty damn good installed. I can assure you there are no other members here that have this on this board.

Pics with a more detailed description of condition, defects, etc will be posted up either later tonight or tomorrow.

$45+Shipping

markmdz89hatch
02-28-2009, 08:19 PM
ok ladies, here's the pics of the grille....

Front:
http://i296.photobucket.com/albums/mm178/mark_mdz/billet%20grille/DSC01005.jpg

Back:
http://i296.photobucket.com/albums/mm178/mark_mdz/billet%20grille/DSC01006.jpg

Ends with mounting tabs:
http://i296.photobucket.com/albums/mm178/mark_mdz/billet%20grille/DSC01007.jpg

http://i296.photobucket.com/albums/mm178/mark_mdz/billet%20grille/DSC01009.jpg

Center where I think there were mounting tabs at one point:
http://i296.photobucket.com/albums/mm178/mark_mdz/billet%20grille/DSC01008.jpg

markmdz89hatch
05-15-2009, 06:52 AM
^bump^ (lowered price a bunch)

markmdz89hatch
07-14-2009, 08:29 AM
...and now we finally have a pic of the damn thing resting in place on the proper bumper:

As you can see in the pic, there's only one zip-tie holding it in place right now. That was just done for the sake of snapping a pic. In order to properly install this it looks like you'll need to remove the two horizontal bars from the center section in order for it to recess properly into the opening. It's also at the wrong angle just because of the single zip-tie holding it in place.

http://i296.photobucket.com/albums/mm178/mark_mdz/billet%20grille/IMG_0429.jpg

markmdz89hatch
09-30-2009, 10:54 AM
bumpoo Anyone out there looking for a one-off?