civic air plenum mod............

[fijisac]

ok so i just got my civic plenum on Saturday and i tried to install it on my carb but da hole is to small, do i was just wondering if i can use sand paper to sand the hole so it fits da carb. if someone can plz help me out or/and give me advice on making the hole bigger plz tell

[Joay]

How much of a gap is there? If it's more than like 1/32" you should probably just use a reducer.

[cygnus x-1]

ok so i just got my civic plenum on Saturday and i tried to install it on my carb but da hole is to small, do i was just wondering if i can use sand paper to sand the hole so it fits da carb. if someone can plz help me out or/and give me advice on making the hole bigger plz tell


A round file would be faster. And a dremel type thing with a metal cutting bit would be faster still.

C|

[lostforawhile]

pictures of what you mean

[fijisac]

ok i will try to upload pic s later to show u guys

[lostforawhile]

i could sell you the intake piece i made but it wouldn't be cheap, special aluminum intake piece that attaches to the carb itself. Lots of work in it so it's not something i would just give away.

[Civic Accord Honda]

hes talking about this

http://www.3geez.com/forum/showthread.php?t=57999&highlight=civic+air+

http://www.3geez.com/forum/showthread.php?t=38108

[lostforawhile]

hes talking about this

http://www.3geez.com/forum/showthread.php?t=57999&highlight=civic+air+

http://www.3geez.com/forum/showthread.php?t=38108I know that cah you forget i made the entire thing by hand and with the temp sensor and air control valve built into it.

[fijisac]

well ok i cut the hole in da plenum and try to fit it on top of da carb and then i ran into a road block:bong:, i think it called to float adjustment screw and it prevent it from sitting flesh on top of da carb so if any1 can plz help by giving some idea's i would b thankful.

[fijisac]

bump, i really need help