View Full Version : CEL code retrieval. question
va_nig_rawr
07-19-2010, 06:40 AM
EOK well I retrieved the code but I'm lost because there was pause butit was a total of 13 but with the pauses it was 1 6 7 so do I have mutiple problems ?
http://www.youtube.com/watch?v=C53GVpgrz6c&sns=em
Here's a video
And its a 88 lxi
that first blink was just to let you know that the ecu is working, after that pause, it flashed a code 6, then paused, then repeated code 6, then paused, and started repeating code 6 again, but your turned the key off after the first flash. code 6 is your engine coolant temp sensor. a common fault & a fairly simple thing to replace if you're somewhat mechanically inclined. it will be a little thing going into the cylinder head (under the distributor area) with 2 wires going to it. that should be removable with a 17 or 19mm socket i think
va_nig_rawr
07-19-2010, 07:44 AM
Oh ok so it just repeats its self? And thank you sir I appreciate the quick and straight forward response
no worries (Y) and yes it just keeps repeating itself over and over
va_nig_rawr
07-19-2010, 10:45 AM
One question can you point me to a DIY cause I've tried the search box but no lucky
Oldblueaccord
07-21-2010, 02:18 PM
Theres on or two post here in the efi section. Look under ECT I think the sensor is called.
wp
va_nig_rawr
07-21-2010, 06:06 PM
ok thanks found one and would you happen to find the parts number for the ect sensor i cant find it to save my life :banghead:
AZmike
07-21-2010, 07:20 PM
It's also referred to as the TW sensor (water temperature). That may help you locate the part number.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.