PDA

View Full Version : Component Setup for 88 LXi



DxNyce
01-13-2011, 07:03 AM
Hello. I've read a lot of posts regarding stereo installation on this forum, and I think I've come to a decision of what I want to do and how I should go about it. This will be a self installation, so I'd like some opinions from posters about the build I'm planning to make. Most of these parts I've seen on crutchfields website, so I'll probably find them on amazon or ebay cheaper.

1988 Accord LXi Hatch

Pioneer DEH-2200UB
CD receiver
http://www.crutchfield.com/p_1302200UB/Pioneer-DEH-2200UB.html

Kenwood KFC-P509PS
Performance Series 5-1/4" component speaker system
http://www.crutchfield.com/p_113KFCP509/Kenwood-KFC-P509PS.html
(I plan to run these from the deck since it can out enough wattage to power them fully. Also trying to figure out where I can mount the tweeters.)

Kenwood KFC-6993PS
6"x9" 5-way car speakers
http://www.crutchfield.com/p_113KFC6993/Kenwood-KFC-6993PS.html
(Planning to run these from the amp below, crutchfields website also says these won't fit in the rear deck, but here on 3geez one of the stickied posts states you can install any 6x9 in the rear deck.)

Pioneer GM-5400T
2-channel car amplifier — 125 watts RMS x 2
http://www.crutchfield.com/p_130GM5400T/Pioneer-GM-5400T.html

RAZR
01-13-2011, 09:25 AM
are u anygood with wiring?

if not i would buy it from crutchfield cause they give u step by step instructions on wiring

MessyHonda
01-16-2011, 11:17 PM
any stereo sounds better than the stock one...if you buy the right jumper for the accord its going to be a plug and play install.