drock
01-16-2011, 09:25 AM
i searched all over and cannot find an exact answer.how do i tighten or loosen the waterpump/alternator belt?
see, my belt started to make a chirp on start up. this is the only belt not replaced since it is a new belt already. so i spray a dab of belt spray on it and it went away but if i blip the gas i get a chirp at low idle. sounds like a bird hanging out in my engine bay making a single chirp lol.
belt definetly might be a bit too tight so i need to mess with it.
if anyone has a link,diagram etc to show me how to adjust the belt, that would be great.
thanks in advance.
see, my belt started to make a chirp on start up. this is the only belt not replaced since it is a new belt already. so i spray a dab of belt spray on it and it went away but if i blip the gas i get a chirp at low idle. sounds like a bird hanging out in my engine bay making a single chirp lol.
belt definetly might be a bit too tight so i need to mess with it.
if anyone has a link,diagram etc to show me how to adjust the belt, that would be great.
thanks in advance.