PDA

View Full Version : 88 LXi, just replaced VSS in trans and reset ECU.


cruzetheskye
10-11-2012, 02:45 PM
Still getting the check engine code for the speed sensor even though I replaced it.

I'm completely out of ideas for this car.
2ndGenPreludeSi
10-11-2012, 02:54 PM
Maybe the part in the cluster??
cruzetheskye
10-11-2012, 03:22 PM
How would I check for that?
Dr_Snooz
10-11-2012, 08:21 PM
You might consider downloading the manual from the wiki and following the troubleshooting diagram for the VSS.
2ndGenPreludeSi
10-11-2012, 09:21 PM
How would I check for that?




Hmm... I dont really know. I honestly didn't even know there was a code for that haha. Maybe its not the same for the lude. What number is it?
ShyBoyCA6
10-11-2012, 10:10 PM
Hmm... I dont really know. I honestly didn't even know there was a code for that haha. Maybe its not the same for the lude. What number is it?

It should be code 17
cruzetheskye
10-12-2012, 12:11 PM
Yeah it's 17
POS carb
10-16-2012, 06:04 AM
From what I remember the part on the transmission only drives the speedo cable and power steering variable assist pump, the actual VSS signal comes out of a part in the gauge cluster
AZmike
10-17-2012, 08:29 PM
From what I remember the part on the transmission only drives the speedo cable and power steering variable assist pump, the actual VSS signal comes out of a part in the gauge cluster

Exactly
Rendon LX-i
10-17-2012, 08:45 PM
Sounds like your pluser is bad. It's the box that the signal gets an sends it to Ecu