PDA

View Full Version : Turbo chagred B20B or A20A3



89AccordGSR
11-12-2002, 02:56 PM
Ok people ive got a couple of questions. First, which is better perofrmance wise, Supercharger or Turbocharger? Second, how hard would it be to turbocharge my A20A3 motor & would it be wroth it? Third, If i did the turbo on my A20 around how much hp & tourqe would I be looking at? Fourth, If I dont do the turbo on the A20, im going to do it on a B20B motor. I plan to have a Type R head on it, if I dropped a turbo on it what should it be coming from, The ITR or The CRV? Fifth, how hard would it be to Twincharge (Supercharge & Turbocharge) a B20B motor? Sixth, would me running dual exhaust pipes (take into mind I plan to do GReddy HKS Dragger mufflers/tips) cause me to lose any HP or tourque? Sorry for the long list of questions, but this is stuff that I really need to know. By the way, on the turbocharging the A20 subject. Justin have you ran your car on a Dyno & if so what did you run?

guaynabo89
11-12-2002, 03:55 PM
If you plan on turboing the a20, the stock f.i. system has to go to see big power increases and keep it reliable.

Figure aroun 5 grand for a half decent setup plus whatever f.i . system you plan on using. Keep an eye on funsticks project and that might make it a little cheaper.

RobT5580
11-12-2002, 05:06 PM
All i can say either way you go its gonna be expensive if your going for a decent PSI. Many pros and cons for both in my opinion. For it to be done properly expect to spend over 5k. Some figures:

Fully built bottom end $3000
Turbo Kit $2000-$3200 (depending if intercooled)
Clutch $300
Fuel Pump/ Bigger Injectors $???
Engine Swap $2500minimum

This is just the beggining i have added up $10k to do a B16A Turbo properly to run a high boost. And Justin has a lot of $$$$ in his hatch for the A20. And he has experience with turbos so expect a lot of trouble if you plan on building your own kit for the A20A unless you know someone with experience with turbos.

Neuspeed87lx
11-12-2002, 07:37 PM
that guy we saw at the meet last week have a turbo 3g hatch a20a3 motor ...he said it was dyno'd at 325 hp

89AccordGSR
11-12-2002, 08:03 PM
Originally posted by Neuspeed87lx
that guy we saw at the meet last week have a turbo 3g hatch a20a3 motor ...he said it was dyno'd at 325 hp
:omg: wheres he at? whats his name?

RobT5580
11-12-2002, 08:07 PM
He also runs over 20Psi so you will definatly need your bottom end rebuilt. One of my issues with the A20 is i think it will be difficult to pass emmisions because for one the egr tube that goes to the manifold will be disconected.

Neuspeed87lx
11-12-2002, 08:25 PM
he was from new haven conn...we saw him run a 12 sec 1/4 mile...could have been faster..