Xenon Bodykit Installation Instructions

Hi 3Geezers, been a while, sorry for that. I was cleaning my garage and found the instructions for installing a Xenon body kit (or any polyurethane flexible kit).

I used 3M Windo-Weld instead of double stick VHB tape on my install, and four or five years later it is stuck on just as good as ever.

Album: https://goo.gl/photos/1av9eBKX6kKnTCc77

https://lh3.googleusercontent.com/XH...g=w529-h939-no

https://lh3.googleusercontent.com/Jh...A=w529-h939-no

https://lh3.googleusercontent.com/MR...w=w529-h939-no

https://lh3.googleusercontent.com/KP...Q=w529-h939-no

thanks for the Info. so far I used rivets on my front bumper because I was really low and dragging it. I have raised my car now but still hits on bump stops and other raised places.

That's good advice Messy.

I had a hard time getting the air dam on the body kit's front to connect to the original bumper along the bottom. I used some coarse thread screws to help it along, but nose into a curb too hard and the screws will pop out.