Printable View
Pulled the alternator out on my 88 LXI to check brushes (while I had all belts off to replace timing belt) and they are less than the recommended 1/4".
My question is - how do I replace them? I have the brush holder out of the alt. I know I can buy the whole brush holder but to just replace the brushes?Looks like I melt the solder on the brush wire but how do the brushes come out of the holder?
I couldn't find any help searching here.
thanks
mike
you got it right on. that's exactly how you do it.
service limit on the brishes is 5.5mm, and standard(new)is 10.5 mm.
hope this helps you out.
Quote:
Originally Posted by Vanilla Sky
So the brushes must "snap" out of the holder? I tugged on them a bit with no luck....
thanks
After a closer look - it appears that the wire actually keeps the brushes from popping out of the holder.Quote:
Originally Posted by vongiese
I'll fire up the solderin iron when I get home and see how it goes.
thanks
mike
don't lose the spring when you remove hte brushes :D
And yes, they are held by the wire.
