Re: Who wants to help install a Weber?
Well my boss has a wood one on his big block in his blazer and it seems to run good. He has drove it cross country with it. Could possibly spray a sealer coat on it so it would soak up the gas. Im gonna talk to him tomorrow.
As for the driving of it, it had a dead spot up until 10mph then it had the throttle respond i would want. Shiftpoints are almost where i want them. I run 55mph alot and where its at it runs 3k rpm at 55 but as soon as i hit 60 it will shift. Its almost there. Little more tweaking and i think she will be there.
Re: Who wants to help install a Weber?
Well here it is. What do you all think? This is a 1/2in maple spacer that my boss and I made today. It wont be till tomorrow afternoon before i can try it out.
http://i1058.photobucket.com/albums/...r1/photo-9.jpg
http://i1058.photobucket.com/albums/...1/photo-10.jpg
Re: Who wants to help install a Weber?
Ok so i couldn't wait lol. I went out there and installed it to make sure it seals good. And it does. Now to change the oil pan gasket. Also, my three lights on the dash (oil filter, oil change and service interval) are red. What does that mean and how do i get them to change back? Oil and filter are new, maybe 200 miles on them.
Re: Who wants to help install a Weber?
Well i recieved my oil pan gasket today. I have everything off and ready to be cleaned and reinstall. Just have to go pick up some mineral spirits and rtv then ill be in business.
Re: Who wants to help install a Weber?
When adjusting the float level in a weber, is there a difference between dgv and dgs? I know the dgv float level but am wondering if my dgs would be the same settings.
Re: Who wants to help install a Weber?
Yes i would think , because you're measuring float drop and the tOp hats are about identical.
The differences in float level basicly depend on engine, sea level, and emulsion tubes .
Text me if you need anything, I have a weber book and carbs unlimites has info sheets on all webers.
Re: Who wants to help install a Weber?
Just a guess but I'd try an unbent paper clip in each of the little slots beneath the maintenance indicators. Mine haven't come on yet or I would have tested this theory already.
Re: Who wants to help install a Weber?
Quote:
Originally Posted by
huntz0r
Just a guess but I'd try an unbent paper clip in each of the little slots beneath the maintenance indicators. Mine haven't come on yet or I would have tested this theory already.
In the manual it says to use the car key in those little slots underneath to reset them.
