4 Attachment(s)
Coolant Hose Connector Popped Off - Now What?
I am currently in the process of replacing all of my coolant hoses on my 1989 Honda Accord SE-i Coupe. On the very last hose, I ended up pulling the hose connector along with the hose. Although neither the connector nor the base that it was attached to appear to be damaged, they don't just snap back into place.
Even after using a hose pick and removal tool, I suspect that the bond between the hose and the connector was still stronger than the bond between the connector and the base.
Any ideas on how to reattach the connector to the base? I found a product called "JB Water Weld" that I think may work in combination with some mild sanding, but I have never used the product myself.
Alternatively, if I could find a replacement part, that could also be a solution. However, I was unable to find any sort of identification marks on the part the connector broke off of (see photos). It has coolant hoses and an electrical connector going to the fuel rail.
Even a temporary solution would be fine as I need to put the car onto a trailer this weekend, as I will be moving to another city.
Any help is much appreciated. Thanks
Re: Coolant Hose Connector Popped Off - Now What?
Quote:
Originally Posted by
Fisher_White
I am currently in the process of replacing all of my coolant hoses on my 1989 Honda Accord SE-i Coupe. On the very last hose, I ended up pulling the hose connector along with the hose. Although neither the connector nor the base that it was attached to appear to be damaged, they don't just snap back into place.
Even after using a hose pick and removal tool, I suspect that the bond between the hose and the connector was still stronger than the bond between the connector and the base.
Any ideas on how to reattach the connector to the base? I found a product called "JB Water Weld" that I think may work in combination with some mild sanding, but I have never used the product myself.
Alternatively, if I could find a replacement part, that could also be a solution. However, I was unable to find any sort of identification marks on the part the connector broke off of (see photos). It has coolant hoses and an electrical connector going to the fuel rail.
Even a temporary solution would be fine as I need to put the car onto a trailer this weekend, as I will be moving to another city.
Any help is much appreciated. Thanks
Since you are in a hurry I would just plug the end the coolant flows from for the time being. I THINK it flows from the rubber you have in the picture to the IACV in your picture. That sensor use coolant to adjust the idle.
You could also get a double ended barb fitting and just fix the hoses together until later.
Either way the car is drivable with out it the idle might be irractic.
Re: Coolant Hose Connector Popped Off - Now What?
It's supposed to be pressed in.
Re: Coolant Hose Connector Popped Off - Now What?
If it will go back in tightly with fair resistance, then the JB Weld might work fine. If it's tight and smooth, even some RTV might be sufficient. I smeared RTV on top of coolant leak years ago and it's still holding up well. Which is great because it will be a mother to fix it properly.
