Printable View
shifter is set. Troubles with length but all fixed after cutting an welding an adding 5 times lol
An who said a b series throttle cable don't work.
http://i728.photobucket.com/albums/w...i/0999e4d3.mp4
An a better view. Point was I didn't want to hack or make my setup look ghetto.
http://i728.photobucket.com/albums/w...i/dcebb86c.jpg
Throttle cable from 94-95 del sol dohc vtec
Don't mind the ghetto loom. I have to redo it
Sweet! Now, get this betch on the road!
Looking good Ren.
Wuts up eith the oil feed line sir??
Ls vtec oil feeding head
http://i728.photobucket.com/albums/w...i/11405234.jpg
http://i728.photobucket.com/albums/w...i/039b9e16.jpg
http://i728.photobucket.com/albums/w...i/1c413920.jpg
http://i728.photobucket.com/albums/w...i/4acf43c0.jpg
http://i728.photobucket.com/albums/w...i/8ba944e1.jpg
http://i728.photobucket.com/albums/w...i/4aaac4c6.jpg
Figure I better throw some pics. Front is is high. Remember a b series is ten times lighter then a a series. But she's on the ground after a year
Bump
NICE!!!! So its finally finished?
So close. Great work. I'm anticipating your fire up video's.
Get that front lowered down a bit, but she's looking good! Glad it's finally back on the ground. Can't wait to see some vids too!
Awesome man! Does she run and move??
Not net waitin on my tuner to fire it up. But it's done voids an ripper vids soon
Hehehe.
that's freakin sweet! Can't wait for the fire up vids.
Moar low and less poke is required :D
dude, get this piece running already!!
No but it's ready ready lol just need to plug in the tuners EEPROM so we can do the initial fire up.
hope its fully broken in for the northwest meet
It will be broken in first 1hr of tuning
The hold up honestly is my tuner is on his honey moon so once he gets back its time lol
Looks great man,what intake manifold is that.
Performer x
Well I was bored an got so so at tig welding. Don't worry it's strong enought it's reinforced like a champ 1/4 inch steel. Well now I'm getting it power coated as well for the extra cleaness.
Cross member
http://i728.photobucket.com/albums/w...i/0e462c8c.jpg
http://i728.photobucket.com/albums/w...i/6e70d07f.jpg
http://i728.photobucket.com/albums/w...i/e8a19531.jpg
http://i728.photobucket.com/albums/w...i/193e2f00.jpg
This is a spare I had . Work has a tig welder an I pratice on some scrap metal then did my piece. Had to do this in order to run my hytech header
