OBD1 map sensors are on the the tb and obd0 is in the black box so you'll have to extend the wires to reach but that's about it
Sent from my SM-N920P using Tapatalk
Leaky rear brake cylinders replaced. And stainless brake lines installed. Glad that's done
Seems like everytime I turn around I got some kind of leak.power steering pump seal hell of a mess got a rebuild kit
Keep going. You'll get there.
"I like to take hammers, and just break stuff, just break stuff." - Beavis
1989 Honda Accord LX-i Coupe, 240k miles, MT swap, rear disc swap
Shop manual downloads available here: CLICK TO VIEW
its worth it once everything is done.
1989 Honda Accord LX-i
B18c1 swap since 7/2011
175whp and 132tq
Swap to the 89 cluster today and I can say I now have a VSS signal it is pretty accurate. It even shows what gear I'm in based on RPMs and speed .And I'm seeing my old cluster and that I never seen the check engine light on because someone remove the bulb
To get a vss signal to your 86 cluster you only need to swap the plastic white box from a 89 cluster I give Rendon LXI the credit thanks bro
Last edited by Shane86; 08-12-2017 at 11:52 PM.
Get that afr down!
Well the water pumps leaking I don't know how I forgot to replace that and the timing belt when I had it all apart. One step forward two steps back as soon as I can get all the leaks and bugs fixed I might be able to put a turbo on it one day
You really can't tell much of a difference but I did a wire tuck on one side without cutting or extending any wires. Still got a lot of work to do
Last edited by Shane86; 06-24-2017 at 03:35 PM.
Tucking wires little by little
Last edited by Shane86; 07-07-2017 at 12:13 AM.
I'm trying to wire in a OBD1 throttle body map sensor .I know the pin out on the OBD1 clip. But I need to know the signal ground and Power on the OBD0 stock harness side. I've been testing with a stock OBD1 sensor tried different wiring combinations and having no luck possibly a bad sensor. Found wire diagram just waiting on sensor
Last edited by Shane86; 07-09-2017 at 01:03 PM.
From the testing I'm done I say that you can not use a obd1 throttle body map sensor as a firewall map sensor. it didn't work for me.
Last edited by Shane86; 07-12-2017 at 07:58 PM.
when you say map sensor are you meaning the Throttle position sensor. Or you mean a Manifold pressure sensor?
Fuse box relocated. I hate wires it's too hot in Florida
Wires cleaned up and fuse box mounted