Donít know if my engine install pics show it, but utilizing the Cheddas traction bar, which eliminates the center trans mount and the front (engine) bell mount, causes the engine to sag rather considerably on the passenger side. This stresses the driverís side mount (I also have the Cheddas mount with urethane bushing) more than I am comfortable with. So I fired up the design software and 3D-printed a prototype trans mount that will utilize the auto mount from the passenger side wheel well. Lucky that this is an auto-to-manual (donít say it Snooz) swap, leaving me that point for a 4th mount. It will utilize the same rubber trans mount that the auto uses in the same location. Also, it attaches where the engine hanger bolts to the trans so I figure thatís a pretty solid point. Itís in plastic right now, but will get it made in the machine shop at school next week or so. I am excited to see if this secures things a bit.