Hi, i was wondering how i would go about to make a 2 step button for my accord with obd0, would i need to convert it to obd1/2? Its got a a20a3 engine.
Hi, i was wondering how i would go about to make a 2 step button for my accord with obd0, would i need to convert it to obd1/2? Its got a a20a3 engine.
No. You need a turbocharger and whole aftermarket ECU. Don't even bother looking further into this, bad idea in the first place.
If you look enough into msd setups, you'll be able to figure out something. I used to use the choke on the stock carb for acting like a two steup. It worked kinda but Ive switched to Weber 38 now and am planning a build with certain things and msd is where ive looked. Got a good base line idea for me. Best of luck though.
Sent from my moto g stylus (2023) using Tapatalk
God... Don't use your choke like that. Msd might be able to, though you'll be a lot better off using a megajolt
And either way, it's not two step, it's just a launch limiter
An MSD 7 should be the answer thats what most drag racers use.
1988 Lxi owner since August 1995
336k miles running strong!
Now running E85.
Oldblueaccord <<< MY YOUTUBE PAGE!
for pops and bangs you need obd1 to pull timing and add fuel. otherwise, it's a launch limiter.
un-motivated!
someone make me an offer i just could not say no to.
3GR
It'd probably pop and bang if you just remove the cat
Bookmarks