2-Step button for honda accord 1988 with obd0

[zuddxxn]

Hi, i was wondering how i would go about to make a 2 step button for my accord with obd0, would i need to convert it to obd1/2? Its got a a20a3 engine.

[ShiRen]

No. You need a turbocharger and whole aftermarket ECU. Don't even bother looking further into this, bad idea in the first place.

[Dana02]

If you look enough into msd setups, you'll be able to figure out something. I used to use the choke on the stock carb for acting like a two steup. It worked kinda but Ive switched to Weber 38 now and am planning a build with certain things and msd is where ive looked. Got a good base line idea for me. Best of luck though.

Sent from my moto g stylus (2023) using Tapatalk

[ShiRen]

God... Don't use your choke like that. Msd might be able to, though you'll be a lot better off using a megajolt

And either way, it's not two step, it's just a launch limiter

[Oldblueaccord]

An MSD 7 should be the answer thats what most drag racers use.

[89T]

for pops and bangs you need obd1 to pull timing and add fuel. otherwise, it's a launch limiter.

[ShiRen]

It'd probably pop and bang if you just remove the cat