Passenger Side Transmission mount install. 1989 Accord

[Blainethemono]

Hello all. I tried to find some info online but havent had any luck. Its for my 1989 Accord Lxi. I noticed the Rubber mount next to passenger fender is torn & Ive ordered a new mount. Im thinking just jack up the transmission, remove rubber gasket install new one. Is it easier to undo the bolt slip it into mount then reattach? Thanks ahead of time for any advice

[Blainethemono]

Thanks I figured it out....

[Oldblueaccord]

Im glad you did because I never have seen a mount like that on an Accord transmission.

[ShiRen]

Yeah, that looked like an exhaust hanger... So real curious what you did

[Blainethemono]

Maybe its a transaxle mount? I put a jack under the engine area to which it was bolted to, lifted her up a hair to relieve tension. unbolted the 2 bolts which hold the lower mount. Removed damaged rubber mount, Rebolted mount plate back to AT with mount attached, slipped upper mount slot into upper pin, lowered jack & that was it. Ill try to post a picture soon.

https://www.ebay.com/itm/28286471113...iABEgKMVPD_BwE

[GrbgePanda]

Clicked on this as I am replacing motor mounts. This rubber piece sits under the transmission.

[Oldblueaccord]

Ah yes its underneath attached to the cross member.