NOT SURE IF THIS IS IN THE CORRECT SECTION
I've noticed that my hood doesn't close flush like it should. It is just a little off. When you look at it, it's just maybe an 1/8" higher that the body and lights. Is there a way to adust this? Nobody else would probably notice this detail, but I do, so I would like to correct it. On my old 89 Crown Vic. it had these "pads" that it rested on, and you could adjust them. I think I may have messed it up when I had to jack up my car from the front one time. Don't ask me why I had to do it, bad memories. Anyway, let me know it there is anything I can do.
Thanks guys.
-Nolan
Bookmarks