Rear Bumper

[87accordlxph]

HELP GUYS!!!

Ahhh!

I decided to take off the rear bumper to repaint it black again but when I put the thing back on the freekin thing looks like it's going to fall off. Basically, the only things that are holding the bumper in place are the screws that hold the mud guards in place.

Man, if I don't support the thing soon it's gonna fall right off!
I don't want to put bolts in on the sides... that would look dumb.

Need some tinkers out there to help me out please.

Thanks in advance guys.

3geez rules!

-Mike from Sarnia!

[shepherd79]

when you take off the rear bumper, you will have bolts on the bottom of it.
on each sides you will have black plastic thing that will slide into a screw type fiting. than you have to snap the bumper into that black plastic.
and than you can secure it with screws.

[87accordlxph]

I did all that shepherd79 and now the back end sags.
There is no longer any support in the middle.
You can move the whole bumper up and then it will fall again in that sagging position.
How can I raise the bumper to the natural position again without it sagging?
Sorry, I guess I wasn't too clear in proposing my question.

Thanks again.

-Mike from Sarnia!