i've been thinking about this for a while and wanted to get some feedback. this is only an idea, won't be able to do it in the near future, but will keep in mind. ok, when you look at 6x9's ,wether they be aftermarket or stock, they are raised up from the board in the back, correct? how would it look to remove the speaker and take out the piece that holds it up higher? when you install them again the would be relatively flush, of course they would come up just a little. if you recover the back then the fabric could be brought right up to the "grill" of the speaker and give it a clean look. say your interior is black and you make the speakers flush in the rear. if you recover then it will have a more flat and clean look to it, correct. i'm hoping i'm stating this in a way that is easily understood. anyway, it was an idea and part of another idea can be related in a way. that idea will be relayed to you a little later. it has to do with a sub enclosure. anyway, let me know if i should elaborate more or what you think of the idea. TIA
Bookmarks