B18A manifold -----> A20A head

[Sabz5150]

Someone posted a picture of where the holes on the B16 manifold should be drilled for it to match up to the 3g head. Anybody know where it is or can post it for me? I searched, but no luck

(edit: sorry for wrong topic, I'm looking for B16 instructions)

[shepherd79]

i know i have seen it somewhere. let me look on my computer.

[PhydeauX]

Get it before my ip changes again

andy

[BITESIZE]

Is that Vtec?

[PhydeauX]

No thats an 88 LX-i manifold with a 90 integra gasket sitting on it. The red dots are where you have to drill to make a b18a manifold work, you also have to drill the blue dot on a b16a. When you go to actually do this get an a20a gasket, tape it to the manifold and where you'll have to drill will be painfully obvious.

andy