B16 Throttle adapt half done. MAP Sensor issues

[1988starter]

Ok I have recently been tring to adapt a civic over bore throttlebody http://cgi.ebay.com/ebaymotors/ws/eB...tem=2429697094 to my accord I have portmatched the TB to the intake and the fast idle controll ports but I am having map sensor issues. When I drive it works fine untill I press the clutch and the RPMs shoot to 3-4 K and sit there untill I am stopped for a bit. I think the reason may be because I am not getting a tight enough seal. ( havent got the nuts on the bolts because of clearence issues. So I have been attaching it with a hgh temp silicone sealer seems to work ok ecept for the map sensor andy input guys. I will try to get picts up later.

[Sean]

remove the studs and use allen head bolts. that should get you enough room.

[k-roy]

Good tip Sean.
If you go to napa you can get a sheet of uncut cork gasket material, you can cut it to make your own custom gasket, that may help with the sealing as well.

[1988starter]

So if I grip the studs with my vice grips and twist they will come out?

Also I have already port matched it so the stock gasket fits perfectly.

[Sean]

yeah grab the studs with vice grips they should back out.

[1988starter]

Originally posted by Sean
yeah grab the studs with vice grips they should back out.

Sweet if my engineeringprofessors ever let up I will give it a try then post picts.

Damn circut analysis/ physics differential crap ect