What's up fellas, I'm about to take my engine and tranny out of my car and I was wondering if anyone knew the size of the bolts that go where the tranny meets the block??? I have a new engine and tranny just sitting on my garage floor but haven't put it on to my engine stand because I don't have the proper length bolts......
cantcha use your bolts from your tranny and and engine to mount it on the stand?
- Col Jack O'Neal - Stargate sg-1."If you were paying attention DANIEL you'd know the Nintendo's pass threw everything!"
Naw because the original bolts are too short, you need long bolts when mounting the engine to a stand..... If I had a spare bolt this wouldn't be too difficult because then I would know the tread pattern so all I would have to do next is find a longer bolt with the same tread pattern.......
Posting Permissions
Reply With Quote
Bookmarks