Alarm - Can't enter program mode... any suggestions?

[POS carb]

I have an SEC-100 Alpine alarm... After hooking everything up I still can't get into the programming mode.

Everything else works, doors lock/unlock, impact sensor works, ignition kill works, lights, valet mode, siren... Just that stupid programming mode...

Basically according to the instructions you are supposed to "Hold the valet switch for 1 second and then press the Mode button on the remote within 1 second" so you can set up all the features like impact sensor levels, active/passive arm, etc.
I can't get it and it is frustrating the hell out of me. Any info?

[POS carb]

hey, here's the PDF of the installers guide, it's Page 4 that describes the programming.

http://www.stylestandard.net/oswego/...DD4CDBB6%5D%5D

help

[POS carb]

n/m I got it... the Normally Closed and Normally Open relay connectioins were reversed on the relay harness it brought, I got it all straightened out now. Thanks.