Caliper bouncing!

[McNick]

Hi All!
My all 4 brake calipers are bouncing because of (sliding pin)-to-(caliper brackets) surface is weared and pin playing inside of bracket hole in all directions. Bouncing is not critical but this IMHO is wery dengerous!

Normally I can replace the pins but what I have to do with weared brackets?!

The local H-dealer dont sell brackets in separate. Only with caliper for about $300.
AEM big brake kit is also too expencive.
J/Y offer only calipers with the same bracket condition.

So what i have to do with this?
Do we have any aftermarket alternative for brackets?
Or rebuilding?
Or I have to use bracket(or whole caliper) for newest H-cars, which can be found on J/Y?

So! Dear 3geez community! What is the right solution?

This short message in my EnGliSh (sorry) was hard to write for me!
So please dont leave my work without your attention!
Tnx.

[shepherd79]

your English is fine. i am from russia and my english is not good.
do you need the braket that holds the caliper to the wheel hub or something else. because i can get all that around here. i am not sure about the rear disk brakes but i know i can get the front ones.