i had got fog lights a while back. i tried 100 watt H3 bulbs in them, but the wiring they came with couldnt handle them. i did all new wiring a few months ago. things i did was replaced the 20 gauge wire with 14 gauge throughout. i intalled a 30 amp relay, 30 amp circuit breaker( instead of a fuse). thats about it. today i got the 100 watt bulbs. i installed them and they a brighter than the 55 watt ones. the power wire nor the ground wire gets hot at all. neither does the relay or circuit breaker. only thing that gets hot is the fog light glass lense. i hope it wont crack if it gets wet while hot. i'd reccomend doing the 14 gauge wiring, 30 amp relay, and 30 amp circuit breaker if you want some powerful bright driving/fog lights. i believe i got a total of about 40 ft of wire. ending up with more than needed isnt a bad thing. here's a diagram of how to wire up the relay into the fog light's circuit.
P.S. where it says fuse on the diagram is where the circuit breaker goes. its basically a fuse. if it heats up, it opens the circuit. when it cools back off, it will close the circuit. no need to replace it like a fuse. saves money.
Bookmarks