Problems After Vac line removal

[RobbyKlotz]

Ok, i just did the vacuum line removal. Now the car will do good to start, i can barely get it over 1000RPMs,and its smoking like a whore and bogs down when i slam it too the floor and i am dripping coolent from somewhere near the back of the carb it looks like. What should be adjusted first? A/F or idle?

I can't figure it out...

[SteveDX89]

Check to make sure you have the coolant line hooked back up to the carb. That could be causing the leaking. I forgot to do that and coolant was everywhere. If it's just a slow leak, check to make sure the clip is tight.

[RobbyKlotz]

Check to make sure you have the coolant line hooked back up to the carb. That could be causing the leaking. I forgot to do that and coolant was everywhere. If it's just a slow leak, check to make sure the clip is tight.

I can fix that when i get back home. Just a retard mistake... Any idea on the starting/idling problem...

I mean, it feels like its getting 0 fuel

[SteveDX89]

Only thing I can think of is to make sure you have vac line #14 hooked up to the back of the carb. I'm pretty sure that draws the fuel in. There are 3 ports on the back of the carb on top. It should be the one closest to the driver's side. That needs to be hooked up to manifold vacuum.

['89AccordLX(Rus)]

What color is the smoke? If it is dark/grey you may be running very rich causing you to experience the bogging down and lack of response. Make sure the choke is not closed. If it is it will cause the engine to run extremely rich. It may start well with the choke in the closed position, but once it warms up it will do what you are describing. Also, since the choke uses vacuum to come off, you may have removed the vacuum lines that allow it to do so. If the choke checks out fine, you may need to readjust your mixture screw. Hope this helps.

[RobbyKlotz]

On the Air/Fuel mixture screw... does screwing it IN lean it out, or richen it up?

[SteveDX89]

Screwing in leans the mixture.

[RobbyKlotz]

She is fixed and running great. Thanks guys

[pixiesfan78]

you didnt say what you did to fix the problem if people come into this thread looking for advice on there problem they wont find the answer unless you give it to them.common curtiousy curtissy courtisy you know what i mean.

[rehv_Aerodeck86]

did u richen the mixture?

[A20A1]

please go back to the how to section and look at the updated vacuum diagrams...