does anybody know where i can get a header exhaust flange that mates to the head? on my header it was cracked and welded, and the heat warpped the flange pretty badly. i tried to heat it up with a torch and bend it straight but its just to badly bent.
-1986 Honda Prelude DX:
pacesetter cat back w/Magnaflow muffler
lightspeed header
ngk iridium plugs
Pacesetter short shifter
94' integra coilovers
k&n oil filter
Did they weld the header while it was still on the head?... usually you do it that way to avoid warping.
http://www.stainlessworks.net/Header%20Flanges.htm
you can send them your exhaust gasket or template and they'll make you one in stainless or mild steel.
.
.
.
- llia
Id send a gasket/template to WeirRacing on homemadeturbo.com (look at the classifieds section), get a 1/2" weld flange and that wont warp wether you weld it bolted to the head or not... prolly cost you $35
429whp 362wtq A20 TURBO. A20T>*
Posting Permissions
Reply With Quote
Bookmarks