Where does this wire run to stock? I see it run into a thick wiring harness thing and I dont have time to take it all apart, the bolt/wire on the top of the alt (not in the 3/4 pin plug) is the +12V right? Can that be run directly to the pos of the batt?
yes it is, it should run to the battery's + post, You can run a new wire if yours is bad, get at least 10 gauge
Eric
3geez member since October 12, 2000
"All this worldly wisdom was once the unamiable heresy of some wise man." - Henry David Thoreau
It runs from the alternator to the under the hood fuse/relay panel. Connects to a 70 amp fuse. The other end of the fuse runs to the battery.
yeah, this is correct. It's important that the alternator's charging wire is fused.Originally Posted by Mac
Chris
http://personalwebs.myriad.net/mouchyn/accordsig.jpg
Of course, everything else has been done in 4awg, would make sense for the positive to be the same too otherwise its quite pointless. 70A good enough for it? They are 65 right?
Posting Permissions
Reply With Quote
Bookmarks