Well I got bored at work last week cause we were so slow... so I made a front strut bar for my car...
Then I decided.. hmmm... I need a back one...
There rear is not complete yet I want to make it a little stronger... but I've put them both through alot of testing and damn.. .They make a great difference....
Last edited by jigga89SEi; 05-30-2005 at 08:40 AM. Reason: Bars not Bats
And now after many questions here it hows...
How Jigga89SEi Got Si seats in his car.... Dun, Dun, Dun
These pictures might be a little difficult to understand... But I just used peices of flat bar and made them fit...
The outside rail on the pass. side I had to cut a 2 squares from the slider part...
On both (pass. and driver) outside I had to straighten out the bracket cause it bends down.. But ours mount flush... Then I proceeded to make the bracket extensions...
If your goin to do this it is easiest to take the rails of the seat and fit them... But make the bolt holes on the new brackets elongated so that you can slide it alittle...
Also keep in mind that my seats are ever so slightly tilted outward respectively on each side.. But u can barely tell by seeing them or sitting in them...
Right rear Passenger side
Right Front Passenger side
Right rear driverside
Left rear driverside
Left front driverside
looks a bit choppy, but good work.
3geez for life.
Posting Permissions
Reply With Quote
Bookmarks