indeeeeeed but he wants power and an a20a carb wont do that unless he does a weber conversion and some other mods
indeeeeeed but he wants power and an a20a carb wont do that unless he does a weber conversion and some other mods
surely some quad carbs would be easier to attatch to a a20/b20 head than they would be to a b18a head? the spacing between intake ports look quite gay on the b18a
why doesnt he just put some twin carbs on the stock twin carb maifold then
the more the merrier :)
so i guess better wait for a h22a halfcut
but now for a short term, need to overhaul my b18a first
btw, thx for ur help guys :)
does ur b18 run without and knocking or anything from the bottom end?
sweet i meant to say if your B18A was running mint like not making any bad noises like loud knocking from the crank/rods? ive only ever seen one b18a that actually ran the rest have rattly bottom ends
i see
just like u've said, a little bit noises from the engine
plus sometimes the idling turn out to be so low, making my car shaking everywhere(suspecting twin carb prob,
this is why i want to change it into injection in the 1st place)
ah, 1 more thing is the noise that came from the carburator(also?)
it's like "ktang ktang ktang" just like when u put a screw into the inlet(but nothing found)
i think got something loose from the air inlet part bcoz when i hold the carburator, it's stop making noise(nvm can be solved when i have a time)
i'm the only 1(that i notice) in my local area that using this ca2
my friends(who r using later model of accord n civics) keep telling me to put in the h22a or b16a
yeah easy for them to say (-_-")
overall, ok but need to replace the lower arm
it give me a bad sound since 4-5 days ago
dunno if i can find it in here, hope so
Last edited by hafizi01; 03-10-2009 at 08:52 PM.
I just noticed that the B18A intake manifold gasket is similar as the B20A3 but upside down
http://pages.videotron.com/omus
3geez member since July 12 2000
I need these parts!
https://www.3geez.com/forum/showthread.php?t=67742
I found better pictures of the B18A Intake manifold on Yahoo Auctions. Obviously, the seller didn't know what he had and labelled it "B20A".
This is clearly a B18A manifold.
Notice the square ports and stud spacing. This is really the same thing as a B20A3
http://pages.videotron.com/omus
3geez member since July 12 2000
I need these parts!
https://www.3geez.com/forum/showthread.php?t=67742
Bookmarks