Last edited by Acid X; 09-30-2005 at 10:04 PM.
nice, good choice IMO!
Kevin
wheels are hot.. next on list should be a drop, but im sure you already know that. props to you.
Haha you didnt read the post.. I said im droppin' it 2.5![]()
damn those are hot.
3geez for life.
i dont think the edit was up there before i posted.. oh well.. itll definitely look hot after that drop you got planned.
Man, those look very nice, are those 15's?
03 Nissan Maxima 6spd 3.5L -- Daily Driver
96 Civic Ex-T 210whp/183wtq @ 9.5 psi tuned on Hondata s300 -- Now at 12psi, unknown power
04 CBR600RR - Sold, and now wrecked. RIP
Thats HOT!.... now hurry up with the drop
My Project thread https://www.3geez.com/forum/project-c...dan-build.html
My Flickr: http://www.flickr.com/photos/jdmca5/
just don't go cheap with the drop, it will ride like ass,
what are the specs on the wheel, weight and offset?
I'm your local R&D nut. Fabracting, welding, tuning and breaking my stuff so you don't have to.
Lookin' good
nice. i was looking at those same wheels, 16's right? i dont think they make them in 15"....
where did you get them, and for how much?
I got the wheels here: http://www.buywheelstoday.com/products/?id=303
Anywho, these are 16x7, 42 offset. I'm not sure about the weight, but i do know that they are aluminum.
I have some Dropzone springs that will lower the car either 2.25" or 2.5", and im buying some tokico struts in a few days. Then in about a week it will be time for the drop!
I'm excited, and i've heard that Dropzone coupled with Tokico make for a good ride..
I love the tires, too. They provide a very nice ride for low-pro tires.
Only thing im worried about with the drop is that the tires might hit the rear quarter panels beacuse the side of the tire is about even with the outside of the car, and then theres that little lip that i have to worry about clearing even if i am wrong about the tires being out as far as the quarter panel...
Bookmarks