painted hub/arm put in new ball joint

[SQ is the SQUAD]

i got bored so i started rebuilding my suspension

removed everythnig, git it a few times with an air powered wire brush, cleaned it primered it, painted. then i threw in a new ball joint





i also painted the hub to my aem big brake kit

[Deadhead]

hey ya.... you want to do that to mine also? :P


Looks nice...

[lostforawhile]

I've had mine beadblasted for years now,with just a protective coat,need to get them powdercoated,haven't had the money for new ball joints and wheel bearings yet. plus new dust shields. I've got them all disassembled and the wheel hubs are already powdercoated and ready for new studs.

[SQ is the SQUAD]

i nkow my dust sheilds came out crappy but you wond see them behind my BIG BRAKES!!!!!!!

sorry for the big pic, ill resize it later.

i dident mean to get paint on the bearing.

hub bearing seem to be in good condition

[lostforawhile]

oh I wasn't waying anything about your dust shields,I was talking about I need to get a set for mine,the ones that came on these hubs were toast. The car was sitting on them at the junkyard.

[EricW]

Looks good. I think I will do that before I upgrade to the SE-i brakes and big brake kit in the front.

[HondaBoy]

i wonder if i has a bit more money if i'd do that kinda stuff when i get board? looks good. i'd like to get parts off another car to rebuild and clean up. then when i get other suspension parts i can install them.