i just got a set of six spoke 16's for free with good tires on them from a buddy of mine. problem is they are offset for a bmw and they rub even though my car is stock height, my question is can i get the rims machined and if i can what type of place does this.
^the new ride^ Mazda rx-7.. gettin 'r done without pistons since 1978
"Spoiler size is inversely proportional to wee-wee size"
the ex - 3rd gen owner
get some spacers
and some pics
sorry for the delay pics will be up later but the problem with the rims is they stick out to far, which is why i was asking if i can get the hubs of the rims machined
^the new ride^ Mazda rx-7.. gettin 'r done without pistons since 1978
"Spoiler size is inversely proportional to wee-wee size"
the ex - 3rd gen owner
just sell them and with that money use it as a downpayment for a new set of rims that are ment for our cars...you will also get to pick better rims that flow and fit the car...just my $.02Originally Posted by white ricer
1989 Honda Accord LX-i
B18c1 swap since 7/2011
175whp and 132tq
Redzone tuned
Posting Permissions
Reply With Quote
Bookmarks