Hmm this may belong in carb tech but it's for a 66 Mustang so I dunno
anyways the thing is that the carb is flooding like it has a flooded float bowl but I can't find a sight glass anywhere or a screw to set it but I noticed it says "Weber" on it also and I remember reading that some webers don't have floats, but I can see the fuel puddling and the car idles shitty and very rich.
what ever shall I do? anyone know about these carbs?
:ego:
Eric
3geez member since October 12, 2000
"All this worldly wisdom was once the unamiable heresy of some wise man." - Henry David Thoreau
oh and yes, of course I've thought about bolting that to my 3gee :super:
Eric
3geez member since October 12, 2000
"All this worldly wisdom was once the unamiable heresy of some wise man." - Henry David Thoreau
Hmm...custom 4 barrel manifold, I like it!
Good bye to the 1989 DX Type R. Hello 2001 LX.
DX:
"Four wheels, four doors, and no frills."
All righty now, Jim see's carter AFB, Jim thinks carter Air Force Base
Hmm is eric going military on us lollol:
carb, oh I see
H&R springs revalved Bilstein front struts, koni struts in the rear 195/55-15 Dunlop W-10's Dc Sports header custom cat-back with Dynomax super turbo w/3" Brembo slotted & dimpled rotor's EBC pads
Well, that's what I used to have, wrecked, 7/3/02.
Now I d
hell why not, ive been moving every other thread on this board toniteOriginally posted by POS carb
Hmm this may belong in carb tech but it's for a 66 Mustang so I dunno
- Joe
All I can say is buy a carter carb book.
- llia
fuq heeellllp meeeeeee.
I hope there's nothing seriously wrong with it... I'll just have to try and find a Carter book I guess.
Eric
3geez member since October 12, 2000
"All this worldly wisdom was once the unamiable heresy of some wise man." - Henry David Thoreau
yummy ! :p what a nice carb !
MIKE
3geez member since October 4th 2001
Don't know about the newer, performance carters, like you pictured, but the older ones didn't have an adjusting screw or site glass! I think you got a rebuild kit,(for gaskets and stuff), then pulled the top off, and bent the floats & tabs! LOL! Here's a link to a exploded veiw Exploded View of a Carter model AFB Carburetor
and this is a page from a real old chiltons manual(circa 1971)Carter AFB
It's not much, but all I got, good luck!
-Steve
Thanks.
Anybody know what the huge bolt at the rear does?
Eric
3geez member since October 12, 2000
"All this worldly wisdom was once the unamiable heresy of some wise man." - Henry David Thoreau
it might be blocking off an unused port.
hmm the weber sets the float the same way... you have to bent 2 seperate tabs... one sets the lowest point of the float the other sets the highest point.
- llia
Posting Permissions
Reply With Quote
Bookmarks