looks good but i can't see all the pics,all i get is red x's.does anyone know why this is.
looks good but i can't see all the pics,all i get is red x's.does anyone know why this is.
who can make it a how to, this was a good one
Great write up,i am getting ready to do my axles and wheel bearing.I have everything i need except for the tools to press out the lower ball joint.You show the tool you used to install but i could not see where you said how you removed them.Thanks for the great info.
Mark
special tool
just take off the snap ring and beat the crap out of it with a large ball peen hammer. try not to hit the wishbone itself. it goes down, in other words hit the end with the threads and drive it down and out. what are you going to do,screw up the old one?. you can reinstall it with a big vise and a socket big enough for the part to go into after it presses through.
Bookmarks