ok I need an answer here,i have just replaced wheel bearings,lower ball joints,spindles,lug studs,upper control arms on both sides,also new upper control arm bushings of course. I can still grab the wheel on the right side and when I rock it at the top and bottom,the wheel will visibly move slightly and I get a clunk. the lower control arm bushings looked good before,could this be it? has anyone else had this problem before? I checked the strut rod bushings,they have slight wear and will be replaced,but the movement is acting like a lower ball joint is bad,but they are new of course. the lower ball joints are moog,so I don't think theres much chance of them being bad,they were properly pressed in, not hammered,wheel bearings the same. any clue?
Bookmarks