Yeah Im thinking round pretty much like the 2nd diagram I made... that should be good wouldnt it?
Some of those are gonna be putting that intake manifold pretty close to your head, I bet this is probably the best way of doing it, but what about half lengths and using the pressure waves to stack up on each other? Itll help either high or low I dont remember.
On bottom 3) What is the purpose of the reduced spot near the head?
Can you give an example of how/where you would merge secondaries?
You can do that without flaring the 2 ends too with just using straight pipe, but its a little harder.
In your diagrams though, where were you thinking of putting the merges, and what size diameters?
Yeah you know what I realized that after I typed it and thought I deleted it. Your right, the intake is at the back
what about the lengths of the tubes? equal? What about the 2 barrel flow?
Bookmarks