bent somthing pleeeeezzzzzz hhheeellllppppppp

[franks89sir]

ok the other day i was on my way to school right and i was turning onto this street and a an alley runs acroos it so this guy in this truck flys out of the aley with out stoppin and if i woulda slamed on my brakes i woulda hit him so i swerved to the left and the (street was wet) and then tried swerving back too the right but i just kept sliding to the left and smacked into the curb just chewed up my rims i so i take it to tires inc and they say my lower control arm is bent so the next day after school i wen tto the junkyard pulled one then put it on my car but it is still toeing inn do u have any other ideas that what might be bent

[franks89sir]

someone pleez help i wanna fix this sas soon as possible

[89lxihb 00lude]

if toe is in you probably bent a tie rod too. Just look at everything and compare it to the other side.

[Jims 86LXI HB]

Sound's to me like you may have damaged it enough that taking it to a shop to be looked over is a good idea, that's what I'd do, even thought I'd really hate to spend the money.

[Justanothermike]

your lower subframe may be bent. its happened before on the white car. actually twice

[Jims 86LXI HB]

Originally posted by Justanothermike
your lower subframe may be bent. its happened before on the white car. actually twice

TWICE You bad boys

[ACCORD EX]

i would compare the left side with teh right side ! and see teh difference !

MIKE

[franks89sir]

ok well i dont know if its toed inn but like the bottom side of the tire is bent inside

[franks89sir]

how did u fix ur sub frame

[AZmike]

You have a shop with the proper equipment either pull it square or they'll tell you they can't fix it.

This sounds minor enough they should be able to fix it. Of course that's just a guess. Good luck Frank.

[POS carb]

check your tie rods.

[doug]

could be that the upper control arm has pulled the unibody outwards

[franks89sir]

Thanx for the info guys well i took it in today and they said all it needed was an alignment so i was happy but i went ahead and replaced the tie rods

[GreenMachine]

I'd say definetly the lower subframe, I'd the same thing except no truck in my way, I was just goofin around with the e-brake on a fri night after it rained - whoops ! I had 7 spoke 17"s didn't bend them at all and had the brakes on so only one spot got curbed but the lower control arm was like an L shape, and of course the sub frame took the rest of the impact .... damn pricey to get that fixed .. I try to do it myself .. good luck wit that

[GreenMachine]

didn't see that last post - well good thing ya lucked out