accel Injectors

[Pico]

Has anyone here ran these injectors or know anything about them.
I'm going to replace the injectors on the rebuilt engine that I'm putting in and I was looking at these or Bosch injectors for a 90 Accord.
here's the link to the Accel ones
http://store.summitracing.com/egnsea...115+4294924930

[MessyHonda]

http://sfbay.craigslist.org/eby/pts/231784395.html

for 280 you can get 310 injectors....im sure that the 4th gen accord injectors work for us.

[EricW]

I wouln't go with anything larger than stock unless you have the need for more fuel. It would be cheaper to just get the stock ones cleaned balanced and blueprinted, at RC its only $24-$28 per injector.

[Pico]

I wouln't go with anything larger than stock unless you have the need for more fuel. It would be cheaper to just get the stock ones cleaned balanced and blueprinted, at RC its only $24-$28 per injector.

Thanks I'll look into that

[MessyHonda]

I ran actual 4th gen injectors successfully. So does everyone that has an EFI a20a. (Same injectors!)

wut are the specs of the 3gee injectors and the 4th gen?

[ZackieDarko]

you can balance injectors?

[shepherd79]

3G injectors and 4G injectors flow the same amount of fuel.
you can got to accel website and download their catalog and they have layout for injectors and which ones are which and how much they flow.
you just have to remember that newer cars starting in mid 90s didn't have resistor box, you can't use them.

[smufguy]

ours flow 240cc and that extra 15cc of flow on the injectors is not gonna do much for you. If you are looking for replacement injectors if your old ones are bad, you are better off looking into good used ones, or just getting your's cleaned and balanced as mentioned above. If you want more fuel, the easiest thing to do is just dial the pressure in on an adjustable fuel pressure regulator... ie if you have one .

[EricW]

you just have to remember that newer cars starting in mid 90s didn't have resistor box, you can't use them.

You can run Saturated injectors (high impedance, no resistor box) if you remove the resistor box and connect the four wires from the injectors to the fifth wire, which provides power to the injectors.

[white ricer]

I wouln't go with anything larger than stock unless you have the need for more fuel. It would be cheaper to just get the stock ones cleaned balanced and blueprinted, at RC its only $24-$28 per injector.

x2.. its just gonna run fugly and get worse gas milage