
Originally Posted by
LX-incredible
I usually warm it up a bit and let it set for a few beforehand. Turn the wheel all the way to the right and locate the drain bolt on the end of the transmission. It has a square insert head, any standard 3/8" socket wrench or extension will fit in the hole. Place a pan underneath and remove the bolt by turning CCW. Let it drain for a few minutes. Now is a good time to clean some of the shavings out of there. Get a small telescoping magnet, even better if you can find a flexible one, but the head needs to be 1/4" or less to get in there. Get comfortable, it might take a while. Carefully insert the magnet and gently move it around inside and to the right of the hole. Remove, clean, and repeat until you stop getting shavings. Do not allow any rocks or shit to get on the magnet and in the tranny. I always flush 1/2 of a quart through, then reinstall the plug, and fill with 3 1/2 quarts. The best thing to fill with screws directly on to the bottle and has a clear vinyl tube that is about 1 1/2 ft long.
Bookmarks