I have almost completed a conversion harness and am stuck on a few things...
Wiring the ELD.
I know the center wire goes to D10 on the ECU, but where do the black and the black/yellow wires go? Ground and ign, or ground and reference voltage (+5V)?
Distributor wiring.
4 new wires need to be run, 2 for the ignition control output signal and 2 crank position wires, which need to be shielded. My question is can I run all four in the same 18-4 shielded cable?
O2 sensor wiring
Pretty much the same as above. Can I run the O2 signal wire and heater wires in the same shielded cable?
D2-BKSW brake switch Grn/wht
What the heck is this and where should it go?
A19-White, Intake control solenoid
Should this be left out, or connected to an air-bleed solenoid?
A16-ALT C alternator Wht/Grn
From what I understand this supplies power to the voltage regulator, so the ECU can control the alternator. Our supply wire isn't wired through the ECU. I would assume it could be left unhooked...
Thanks for your help.
Bookmarks