wiring diagram

[lostforawhile]

hey does someone have the wiring diagram,the factory one,that shows the circuit for the recirculate motor and switch? the motor that is mounted on the side of the blower housing? i need that part of the circuit diagram from there to the switch in the heat air control,possibly from a dx,but i can probably figure it out from the pushbutton control one too. i have built an interesting project from one of those door servo motors, but i need to figure out the four wires. the correct wire color codes for the motor are yellow with red,yellow with green,black, and black with yellow. need the diagram from the motor all the way to the switch assembly. if you scan it just send it to [email protected]. thanks!!

[forrest89sei]

PM Picopop, I know he has one

[Pico]

email sent

[lostforawhile]

thanks

[Pico]

thanks

Forrest sold me the manual just pm me or e-mail me if anything else is needed

[lostforawhile]

it's not on that one,the picture is nice and clear though when i go in faststone and blow it up, it's got to be somewhere in there this is the motor that closes the recirculate door when you press the switch

[Pico]

theres one listed as heater controls let me scan it and e-mail to you

[lostforawhile]

theres one listed as heater controls let me scan it and e-mail to you

k

[lostforawhile]

for some reason they are illegible, the first one you sent was crystal clear,the very first one,these are just a blur

[Pico]

ok I'll redo it

[lostforawhile]

ok i think those are it i got it to clear, color codes are wrong but i can still figure it out. . mystery wire going to the dimmer circuit,but the dimming circuits are on my diagrams in my book, so i can figure out where it goes. this circuit is just ommited from the diagrams i have. this is a very useful little servo motor, every junked car has one and it's geared down a lot, so it should have a lot of torque. if i'm looking at it right when it has ignition power and ground, sending ground to one of two wires wlil cause it to rotate 90 degrees and stop. grounding the other wire will cause it to return to it's previous state. this has a lot of useful applications on motorizing things in the car.

[Pico]

Still need me to try and get a clearer pic to you or can you sort of work it out with that.
I've tried 3 times so far and still trying to get a clear pic

[lostforawhile]

Still need me to try and get a clearer pic to you or can you sort of work it out with that.
I've tried 3 times so far and still trying to get a clear pic

oh i got it. i will try to see if i can get this to work tomorrow.

[Pico]

Cool

[2oodoor]

let me know if you still need wiring schematics, I have the mitchell /shopkey software at work, I can fax it