do 88-89 mounts fit on an 87 ? I've tried searching for about 40mints now and haven't found the answer.
do 88-89 mounts fit on an 87 ? I've tried searching for about 40mints now and haven't found the answer.
i never had a problem doing it
"Weight is relative to power like time is relative to speed"
yeah, but with the front mount you have to take the one from the block as well as the one on the crossmember, cause (i'm not sure about usdm ones, but i think it's like this) the 88-89s have a iron mount on the block & the cross member mount has a long stud for the nut cause of the thick iron mount, where as the 86-87 ones just have a steel mount on the block & a short stud cross member mount. so the 86-87 crossmember mount wont work on the 88-89 engine block iron mount, but it should vice versa. the other mounts are all the same as eachother through the years
Last edited by A18A; 12-18-2008 at 12:11 AM.
didn't know that about the front mounts.
but yeah, sides, dog-bone, rears, and bottom are all the same throughout the years, but the rear ones (both pieces) are different from manual to auto.
-Mark D.
For 86-88 and 89 dx/lx all the mounts are all interchangeable. The front mounts on 89 lxi/sei have different mounts and brackets. At least, from what I remember.
Here:https://www.3geez.com/forum/showthrea...ht=front+mount
Kind of confusing, but by the last few posts it starts to make sense.
Originally Posted by Justanothermike
my A20 is not SLOW. ur A20 is slow.
anyone notice this is in the wrong section
Wouldn't technically engine mounts be suspension?
what does it have to do with suspensionOriginally Posted by Naf's Asdf
Wouldn't technically engine mounts be suspension?
It suspends the engine (guess my funny failed)... But yeah, you're right.
lol i was actually thinking that too ^
get a rear mount for the front and fill it with good poly
1988 Honda Accord LX-i Coupe 123k miles.
Have you tried it? Is the hole spacing on the base flange the same?
You would have to rotate it 90° and I'm wondering if there might be a clearance issue with the top shell and the bracket.
Originally Posted by Justanothermike
my A20 is not SLOW. ur A20 is slow.
i have replaced a front hydro mount with the rear mount and it fit great only thing is u must use the 86-87 front mount bracket. also it would be much stronger if it was filled with poly compared to the OEM hydro mount and will most likely outlast it
1988 Honda Accord LX-i Coupe 123k miles.
Good deal. Sounds like a nice upgrade in durability.
I filled all my mounts except for the front and I keep waiting for it to break, but it never has. Must be my highly refined rev matching prowess (LOL).
Did you have to cut those tabs off the top to get it to fit in the front bracket?
Originally Posted by Justanothermike
my A20 is not SLOW. ur A20 is slow.
Posting Permissions
Reply With Quote
Bookmarks