K20 into the 3gee?
K20 into the 3gee?
Sam
1989 Accord LX: Sold with 208k-now somewhere around 230k with new owner
Current:
2014 Elantra Sport 6MT
2000 Montero Sport 4x4 (beater, trail rig)
yeah, i think i'm going to try and source an RSX with body damage. that or just buy a complete bottom end. the A20 bottom is about $350 from city motor supply out of San Antonio. thats more than likely what i'm going to do for now. i just hate seeing my 3gee sit and not have anything done to it. hopefully my Weber is still going to work, its been sitting for a while.
Keep it HONDA. Or at least Asian.™
*Weber 32/36*Pacesetter Header*2.25 in. Cat Back exhaust*SE-i rear disk brakes
B18C swap ditched, A20 to be revived
Looking for K20/trans for ultimate swap
nice to see you back
1989 Honda Accord LX-i
B18c1 swap since 7/2011
175whp and 132tq
Redzone tuned
dude $200 for a b18c1-don't go near that I can 90% assure you its stolen,I have a built LS bottom end if you want a legit motor,Eagle rods,JE pistons .020bore,balanced and blueprinted,ready to go just needs a head for $725
I have a b18c1 bare block you can start from scratch from for $60
lemme know you know where I reside lol
so whats the plan? k or b
1989 Honda Accord LX-i
B18c1 swap since 7/2011
175whp and 132tq
Redzone tuned
B is cheaper since the mounts are already made....K SERIES is alot. of fab. cable ran trans. backwards motor...would be nice but cost you more then anything
200+ ALL MOTOR LS VTEC
i am thinking about doing a b18 swap two what wire harness would i use its my first swap soo work with the noob
TWISTED DYNASTY
Custom...-_-
1988 Honda Accord LX-i Coupe 123k miles.
Hasport Performance I think used to offer a service on their website that if you sent them the two harnesses, they would do the work for you (for a fee of several hundred dollars of course). I emailed them to ask if they could do a CA5 to B18A1 (Integra LS non-VTEC) wiring harness. Hopefully I hear back today.
kewww i also have another question what axles would i use?? i was thinking about that when i was removing the a20 axles today
TWISTED DYNASTY
hey if you still have it, i'll keep that in mind.Originally Posted by wprocomp
i'm probably going to put a new A20 bottom end in and just get the thing running. most likely in the summer.
Keep it HONDA. Or at least Asian.™
*Weber 32/36*Pacesetter Header*2.25 in. Cat Back exhaust*SE-i rear disk brakes
B18C swap ditched, A20 to be revived
Looking for K20/trans for ultimate swap
Bookmarks