Swapping B18C1

[russiankid]

K20 into the 3gee?

[HondaBoy]

yeah, i think i'm going to try and source an RSX with body damage. that or just buy a complete bottom end. the A20 bottom is about $350 from city motor supply out of San Antonio. thats more than likely what i'm going to do for now. i just hate seeing my 3gee sit and not have anything done to it. hopefully my Weber is still going to work, its been sitting for a while.

[MessyHonda]

nice to see you back

[wprocomp]

dude $200 for a b18c1-don't go near that I can 90% assure you its stolen,I have a built LS bottom end if you want a legit motor,Eagle rods,JE pistons .020bore,balanced and blueprinted,ready to go just needs a head for $725

I have a b18c1 bare block you can start from scratch from for $60

lemme know you know where I reside lol

[MessyHonda]

so whats the plan? k or b

[Rendon LX-i]

B is cheaper since the mounts are already made....K SERIES is alot. of fab. cable ran trans. backwards motor...would be nice but cost you more then anything

[Dat88Monstar]

i am thinking about doing a b18 swap two what wire harness would i use its my first swap soo work with the noob

[Civic Accord Honda]

Custom...-_-

[Edison Carasio]

i am thinking about doing a b18 swap two what wire harness would i use its my first swap soo work with the noob

Hasport Performance I think used to offer a service on their website that if you sent them the two harnesses, they would do the work for you (for a fee of several hundred dollars of course). I emailed them to ask if they could do a CA5 to B18A1 (Integra LS non-VTEC) wiring harness. Hopefully I hear back today.

[Dat88Monstar]

kewww i also have another question what axles would i use?? i was thinking about that when i was removing the a20 axles today

[mykwikcoupe]

Hasport Performance I think used to offer a service on their website that if you sent them the two harnesses, they would do the work for you (for a fee of several hundred dollars of course). I emailed them to ask if they could do a CA5 to B18A1 (Integra LS non-VTEC) wiring harness. Hopefully I hear back today.

contact angus LX-Incredible. He biult my harness and does amazing work. It looks better then stock and he will make it however you want. Ive posted pics in a few of my threads. You wont be sorry

[HondaBoy]

I have a b18c1 bare block you can start from scratch from for $60

hey if you still have it, i'll keep that in mind.

i'm probably going to put a new A20 bottom end in and just get the thing running. most likely in the summer.