A list of the things that will need fixed for it to pass the inspection test in Nov

[hondarules!]

New brake pads and disks (worn down to nothing)
New wheel bearings all round
New ball joints o/f and n/s
new brake master cylinder (brake pressure WAY to low lol)
new tyres (all bald)
new steering box (steering locks sometimes, not too safe eh! lol)
New exhaust (rusted and corodded)
New Exhaust Gas Recirculation Valve (prone to stalling and slow acceleration)

Thats it.

I priced it at $4,255 to get her road worthy for the next inspection test. I think ill be buying a new car then huh! lol. See ya L8R guys! Plus she might need a new clutch then as well.

[mykwikcoupe]

no I bet you can find most of for super cheap or rebiuldable on a bench with a few tools and some knowhow. the master cylinder is a 100i think. Pads/shopes less than 40 unless you want to get fancy. The steering box Im sure is good and the problem is lack of fluid or a bad baffle in the pump. The exhausts can be found elsewhere for about a bill. I bet if you started at a few huinderd and started biulding. Save the bearing for last. It can be done.

[MessyHonda]

damn that is dealer rate....you can find all that stuff for under 1000 bucks on like rockauto...but yeah just find a new beater hope it last longer