NOICE.....great work.....thread jacker lol
NOICE.....great work.....thread jacker lol
200+ ALL MOTOR LS VTEC
No, I am not. It did indeed make a huge difference.
Anyone know the diameter of the stock shifter shaft, below the top threaded section, where it widens?
thanks!
1989 Accord LX-I - Brembo f.Rotors, Hawk HP+ pads, ATE fluid
1996 Mustang Cobra #404 - somewhat stock
never knew this was possible
haha matt you maori.
good work rendon
Bringing back this great howto.
http://www.ebay.com/itm/390467181897?redirect=mobile
That's the same as yours huh? Jusst wondering cause I'm doing this mod
Sure will
200+ ALL MOTOR LS VTEC
I just took a sleeve out of top shock mount ,cut the bottom piece in half and welded the sleeve in.
Bookmarks