OBD1 IMA sensor help

[AccordB20A]

okay as some of you know i have converted my car to OBD1 using a EDM ecu p27

i have this error code 11 which is IMA sensor. what i want to know is where on the obd1 ecu does this sensor go in, its not listed on obd1 pinouts on the internets cause its an edm only thing for cars that dont have o2 sensors or catalictasdgfyubv converters

HHEELLPp its the last error code i need to get rid of haha

[89T]

http://www.marklamond.co.uk/tech-hon...-code-list.htm

my best guess is it's in the ecu.

[carotman]

http://media.honda.co.uk/car/owner/m.../400/6-180.pdf
http://media.honda.co.uk/car/owner/m.../400/6-182.pdf

Pin D22 is the ground, Pin D20 is the reference voltage and pin D10 is the actual input. (0.5-4.5V)

My guess is that you could just use a spare TPS sensor in place of that IMA thing

Check this online manual for UK CB Accords. This will help you a bit I'm sure.
http://media.honda.co.uk/car/owner/m.../AccordManual/

P.S.
Ok, now you owe me some nice shiney JDM parts (I'll pay for them of course). I'll send you a PM with what I need :p

[AccordB20A]

haha i just downloaded those pdfs a few minuites ago. the jdm/usdm pinout says ELD on pin d10 but this ecu doesnt have a ELD because i didnt get a code for it and my acord doesnt have one. i have a IMA from a crx ill chuck in there tomorrow night, Ill have to modify my wiring loom also to make the digital dash work again, it cant figure out how much fuel im using on the OBD1 ecu

cheers dude and ill see what i can do :P