timing belt

[8855A]

Replaced timing belt and used diagram from Auto-Zone, but forgot to line up flywheel marks, do I have to do the whole process all over again or can I just remove the timing belt off camshaft and turn crankshaft till the flywheel marks line up and then line up camshaft and replace timing belt?

[2oodoor]

No, I explained how to get it right in your other thread... unless Im not supposed to see this one and you seek a second opinion. lol
Hopefully there was no notable damage and your noise was preignition.
The procedure I explained can be done without removing anything other than top T belt cover.
The purpose of removing the plugs is so the engine will turn over freely with the ratchet and you can get it lined up much easier.

[8855A]

NO that wasn't it! what you said was what I needed, thank you so very much! The motor is just fine, just need to do what you told me! Was on a different web-site and forgot where I posted, THANK YOU ROODOO2!